How to Wrap a GMC Sierra 1500

Mendy

November 7, 2022

How to Wrap a GMC Sierra 1500
Table Of Contents

The GMC Sierra 1500 is one of the hottest trucks of 2022. But when it comes to how to wrap a GMC Sierra 1500 truck, there are many factors to consider.

Do you want a partial or full wrap? What’s the difference between the two? How do you go about doing it yourself or hiring a professional? And what kind of maintenance is required for your truck wrap? In this blog post, we will answer all of these questions and more!

How Do You Wrap a Truck?

The first step is to determine how much of the truck you want to wrap. A partial wrap usually just covers the lower half of the vehicle, while a full wrap covers the entire truck.

Once you’ve decided on the extent of the wrap, you need to gather your supplies. For a partial wrap, you’ll need vinyl wrap film, scissors, and a utility knife. For a full wrap, you’ll also need painter’s tape and an air blower.

The Basic Steps to Wrap a Truck

Now it’s time to start wrapping! If you’re doing a partial wrap, begin by cutting the vinyl film into strips that are about 6 inches wide. Start at the bottom of the truck and work your way up, overlapping each strip by about half an inch. When you get to the door handles, use the utility knife to cut around them carefully.

For a full wrap, begin by taping off the edges of the truck. Then cut the vinyl film into panels that are about 4 feet wide. Start at the bottom of the truck and work your way up, overlapping each panel by about an inch. When you get to the door handles, use the utility knife to cut around them carefully.

Once you’ve wrapped all of the desired areas of your truck, use the air blower to remove any wrinkles in the vinyl film.

What’s the Difference Between a Partial and Full Wrap?

The main difference between a partial and full wrap is how much coverage they provide. A partial wrap usually just covers the lower half of the vehicle, while a full wrap covers the entire truck.

Another difference is that a partial wrap is less expensive and takes less time to install. However, a full wrap provides more protection for your truck and can last longer. A Partial wrap for a GMC Sierra could cost around $1500 – $2500, while a full wrap will be closer to $5500. Contact us today for an exact quote for your truck, as costs will vary based on coverage and vehicle type.

DIY vs. Professional Truck Wrap Installation

Installing a truck wrap is not a difficult task, but it does require some time and patience. If you’re short on either of those, you may want to hire a professional to do it for you.

Pros:

– Save money

– Can be done in a day

Cons:

– Time-consuming

– Requires patience

If you decide to DIY, make sure you have all the necessary supplies and take your time. It’s better to do it right the first time than to have to redo it because you rushed through it.

Maintenance for Your Truck Wrap

Once your truck wrap is installed, there are a few things you need to do to keep it looking its best.

First, wash it regularly with a mild soap and water solution. This will help remove any dirt or grime that could damage the vinyl film.

Second, avoid parking in direct sunlight whenever possible. The heat from the sun can cause the vinyl film to warp and fade over time.

Third, don’t use harsh chemicals or cleaners on your truck wrap. This includes things like gasoline, oil, or WD-40.

By following these simple tips, you can keep your truck wrap looking great for years to come! Ready to get started? Reach out for a free quote today!

Connect with a car wraps expert today!